Making Crown Skinnier at Midsection

Discussions about the use of Realflow
Post Reply
Posts: 18
Joined: Thu Jun 13, 2019 10:08 pm

Making Crown Skinnier at Midsection

Post by Polyguy » Tue Jul 02, 2019 10:10 pm

Hey again all. I'm posting so much!!! I apologize. Trust me, I do so much research, but can't find these answers...

I'm looking to match the liquid drop on the right. I'm pretty close, however, the yellow crown on the right has a skinnier mid-crown section. It tapers in a much more pleasing way. Both of these animations are screencapped at their peak crowning. I've been working on this simulation for over a week, and I can't achieve this affect. I've tried all different crown shapes, gravity settings, crown timing and lifespan, everything...but I can't get the crown to look like the yellow image on the right...

I almost wish there was a second handle controller on the crown daemon, so I could taper in the crown mid-point down...

Is there a way to achieve this?

Thank you in advance.
Liquid_Drop_SkinnyCrown.jpg (55.32 KiB) Viewed 4156 times

Posts: 8
Joined: Thu Oct 30, 2014 6:55 pm

Re: Making Crown Skinnier at Midsection

Post by elflavio » Wed Feb 05, 2020 4:35 pm

Are you using SPH ? this method works better for that effect. The macro deamon could help with that as well.

Post Reply

Return to “Realflow”