Page 1 of 1

Fit hybrid mesh to object

Posted: Tue Jun 19, 2012 10:40 am
by Mikel
Hello again.
I'm making a hybrid simulation of a sea that hits a wall round
I've noticed that Grid Fluid Domain does not fit the curve of the wall.
Before you fit the distance of the emitting objects with collision distance, but now can not find the way.
I put a picture
The problem comes when creating the grid mesh, falls far from the wall.

Re: Fit hybrid mesh to object

Posted: Wed Jun 20, 2012 7:54 am
by scubedio
Hi... increase the resolution of ur domain or particle sampling.....

Re: Fit hybrid mesh to object

Posted: Wed Jun 20, 2012 9:23 pm
by Mikel
Thanks

Re: Fit hybrid mesh to object

Posted: Fri Jun 22, 2012 8:41 am
by bitSeq
This has always been a problem with hybrido, one trick we have used in the past is to scale down the collision geometry, then you can get the mesh right up to the edge of the original geo.