Discussions about the use of Realflow's Renderkit
2 posts • Page 1 of 1
I am extending the surface of my hybrido domain and I can define the boundries of the extension but cannot rotate it! My domain is rectangle but the projection plane is about 30degrees at an angle and it will slice my domain at an angle. I did unlock the "rotate Y" in the channel box and can rotate the Projection plane but it makes no difference whatsoever. Whats wrong?!
- HyDomain and projPlane just inside domains borders
- domin.JPG (138.1 KiB) Viewed 1548 times
- Rotating the projection plane to my HY Domain for proper extension does not make a difference
- ProjPlaneExt.JPG (40.81 KiB) Viewed 1548 times
No ideas anyone!???
Who is online
Users browsing this forum: No registered users and 1 guest