How to Extend the simulation??

Discussions about the use of Realflow 3
CapitanRed
Posts: 73
Joined: Wed Sep 13, 2006 7:24 pm
Contact:

How to Extend the simulation??

Postby CapitanRed » Sat Sep 30, 2006 1:01 pm

Is there no way?

i'm asking, because i have a long simulation, and in the begining the simulation is ok. and the next thing which happens, happen after 700 frames.
and when i reset, i allways have to go from 0.
but when i go back to frame 700, and start simulating, it does not simulate right. My RW gets a hole in the middle.

now i think i could export the rw. but then i have to go to max. render the first 700 frames.then go back to RF, simulate the next 300 frames, and then again go back to max.
and i don't know if there will be a smooth blend.:glare:
there must be a shorter way.
www.Capitanred.carbonmade.com


CapitanRed
Posts: 73
Joined: Wed Sep 13, 2006 7:24 pm
Contact:

How to Extend the simulation??

Postby CapitanRed » Wed Oct 04, 2006 11:48 am

so, the best way i found for doing this, is save the simulation at a frame, where another condition starts.
and in stead of resetting the sim, i just open again the file. it takes some time, but it woeks:)
www.Capitanred.carbonmade.com


Return to “Realflow 3”

Who is online

Users browsing this forum: No registered users and 1 guest