Hello and one easy question

users may introduce themselves and post OT here
zorko
Posts: 3
Joined: Thu Jan 17, 2013 2:51 am

Hello and one easy question

Postby zorko » Thu Jan 17, 2013 3:08 am

Hello,

I am brand new user of RealFlow 2012 with total of 2 hours experience. In this time I have created a simple scene and I can run Simulate just fine but when I run preview I don't see any fluids. In first screenshot you can see the setup. Second screenshot shows the preview.

It must be something very simple and obvious but I can't figure it out! Are there any step by step tutorials?

Thank you.
Attachments
RF forum 2.PNG
RF forum 2.PNG (239.39 KiB) Viewed 2257 times
RF forum 1.PNG
RF forum 1.PNG (202.88 KiB) Viewed 2257 times


User avatar
ChristianZ
Posts: 3278
Joined: Sat Sep 09, 2006 11:37 am
Location: CH

Re: Hello and one easy question

Postby ChristianZ » Thu Jan 17, 2013 3:28 pm

The answer is probably the fact that you are using the demo version.
The demo does not save the particles on the hard disc (don't know if you could export the preview while running the sim in the demo. Its possible in the full version).
RF10 standard, System specs: OSX 10.11, MacPro 4.1 2xXeon, GTX980Ti, 64 GB RAM

zorko
Posts: 3
Joined: Thu Jan 17, 2013 2:51 am

Re: Hello and one easy question

Postby zorko » Thu Jan 17, 2013 6:41 pm

Thank you for prompt reply. Too bad you can't make the video (low resolution or with watermark).


Return to “Introductions and OT”

Who is online

Users browsing this forum: No registered users and 1 guest