Milk

Showcase your finished work
User avatar
kapellan
Posts: 38
Joined: Fri Mar 18, 2011 3:05 pm
Contact:

Milk

Postby kapellan » Wed Jun 15, 2011 12:44 pm


Realflow 5
res 5
den 1000
int p 1
ext p 1

daemons
drag_force strength 0.1
Gravity 9.8
Noise strength 70; scale 1 bounded
vortex rot 5; central str 15
k_volume


vis 30
surf t 0

fps 60
min sub 5
max sub 30

ST 01:04:07
particle 304140

fps 120
http://andre-sv.blogspot.com/2011/06/milk.html


User avatar
StephaneS
Posts: 85
Joined: Tue Jan 05, 2010 1:09 pm
Contact:

Milk

Postby StephaneS » Thu Jun 16, 2011 11:28 am

Very nice, congratulation.

User avatar
matt_Johnson
Posts: 81
Joined: Sun Aug 26, 2007 2:48 am

Milk

Postby matt_Johnson » Fri Jun 17, 2011 3:44 am

This is looking good, however, it does have a certain glue type feel to it. Have you though about adding foam?
3D FX Artist

User avatar
kapellan
Posts: 38
Joined: Fri Mar 18, 2011 3:05 pm
Contact:

Milk

Postby kapellan » Fri Jun 17, 2011 7:48 am

matt_Johnson wrote: This is looking good, however, it does have a certain glue type feel to it. Have you though about adding foam?

Thanks!

I plan to completely redo the simulation. Reduce viscosity and to write a script cleaning the hole. I think the foam would look better

User avatar
BrianLooney
Posts: 585
Joined: Mon Feb 11, 2008 2:19 am
Location: Sand Springs OK

Milk

Postby BrianLooney » Sat Jun 18, 2011 2:23 am

Its a good start. The milk shader needs work. It's too white. It needs some SSS with a slight bit of yellow.
Brian Looney
Tulsa, Oklahoma

User avatar
glynius
Posts: 264
Joined: Fri Sep 14, 2007 11:41 pm
Contact:

Milk

Postby glynius » Wed Feb 08, 2012 9:41 pm

i think that meshing is also a problem here. when the wave collapses to the surface you get no splash, instead of this, the meshes that should interact, becomes one. This is also my problem when meshing...

angel_airlines
Posts: 48
Joined: Thu Jan 18, 2018 11:16 am

Re: Milk

Postby angel_airlines » Fri Jan 19, 2018 8:57 pm

It is a nice mesh... is it possible to get the values of the the mesher?

I suppose the balance between the thinning and the smooth values is the key here...


Return to “Finished Work”

Who is online

Users browsing this forum: No registered users and 3 guests