Page 1 of 1

Pouring viscous liquids

Posted: Sun Jan 04, 2015 9:42 pm
by trance

Re: Pouring viscous liquids

Posted: Sun Jan 04, 2015 10:27 pm
by ChristianZ
Nice

Standard particles or hybrido?

Re: Pouring viscous liquids

Posted: Wed Jan 07, 2015 6:27 am
by trance
ChristianZ wrote:Nice

Standard particles or hybrido?


Thank you! Standard :)

Re: Pouring viscous liquids

Posted: Wed Jan 07, 2015 9:55 am
by ChristianZ
Thanks for answering.

I haven't tried yet the hybrido viscosity but wonder if it would look different in a side-by-side comparison.

Re: Pouring viscous liquids

Posted: Fri Jan 09, 2015 8:42 pm
by trance
ChristianZ wrote:Thanks for answering.

I haven't tried yet the hybrido viscosity but wonder if it would look different in a side-by-side comparison.

Hmm I'm curious too, will have to try that out. If there's no difference I would stick to the standard particles, since there aren't many steps involved.

Re: Pouring viscous liquids

Posted: Fri Jan 09, 2015 10:16 pm
by Oldcode
Hey guys,

One thing I'd really like to know about the Hybrido Viscosity is do they have something like "Sticky"?

I've been too busy to look, but I've not seen anything in any of the controls to add stickiness. Without stickiness, high viscous fluids have a lot less usefulness.

Re: Pouring viscous liquids

Posted: Sat Jan 10, 2015 7:33 pm
by trance
Oldcode wrote:Hey guys,

One thing I'd really like to know about the Hybrido Viscosity is do they have something like "Sticky"?

I've been too busy to look, but I've not seen anything in any of the controls to add stickiness. Without stickiness, high viscous fluids have a lot less usefulness.

Hmm this example seems to use the stickiness well, but I think it was done with standard particles.
https://www.youtube.com/watch?v=EqISeHeeOm8